Item Description
120W 24V DC Spiral Bevel Appropriate Angle Brush Equipment Motor
Solution Description:
Equipment Motor-Torque Desk Allowance Torque Device:Upside (N.m)/Belowside (kgf.cm)
•Gearhead and Intermediate gearhead are marketed individually.
•Enter the reduction ratio into the blank() inside the product title.
•The velocity is calculated by dividing the motor’s synchronous velocity by the reduction ratio. The real speed is 2%~20% considerably less than the displayed price, dependent on the dimensions of the load.
•To minimize the speed CZPT the reduction ratio in the following desk, attach an intermediate gearhead (reduction ratio: 10) between the reducer and motor. In that circumstance, the permissible torque is 20N.m.
Proportions(Device:mm):
Company Info
FAQ
Q: What’re your principal goods?
A: We at the moment make Brushed Dc Motors, Brushed Dc Equipment Motors, Planetary Dc Gear Motors, Brushless Dc Motors, Stepper motors, Ac Motors and Large Precision Planetary Gear Box and so forth. You can verify the technical specs for over motors on our website and you can e-mail us to advise necessary motors for each your specification too.
Q: How to select a appropriate motor?
A:If you have motor photographs or drawings to display us, or you have thorough specs like voltage, velocity, torque, motor dimension, operating mode of the motor, needed life span and noise degree etc, remember to do not hesitate to allow us know, then we can recommend suitable motor per your request accordingly.
Q: Do you have a customized service for your standard motors?
A: Of course, we can customize for every your ask for for the voltage, velocity, torque and shaft dimensions/form. If you want further wires/cables soldered on the terminal or need to insert connectors, or capacitors or EMC we can make it too.
Q: Do you have an person design and style provider for motors?
A: Sure, we would like to layout motors independently for our buyers, but it might want some mildew establishing value and layout demand.
Q: What is actually your guide time?
A: Normally talking, our typical standard solution will want 15-30days, a bit lengthier for tailored merchandise. But we are really versatile on the guide time, it will depend on the distinct orders.
Remember to speak to us if you have in depth requests, thank you ()
Specific pitches and leads of the worm do not enable the worm equipment to travel the worm. This is useful when the software needs to lock the output if the software is working in the reverse route. When the helix angle is much less than 5°, the worm is self-locking. When the helix angle is higher than 10°, the worm can be driven again. Worm and worm gear assemblies have to be mounted on vertical, non-intersecting shafts.
